Clean plug in cable connections at both ends.
Arctic spa control panel not working.
Is your arctic spas hot tub not working.
Canadian built with the finest materials and advanced technology to withstand even the harshest of weather conditions arctic spas are made to perform wherever you happen to live.
If all seems well then you may need to replace your control panel or consult your hot tub dealer.
For a control panel that is unresponsive with no leds or temperature reading check the wiring harness from the spa pack to the circuit board for a loose connection or damaged wire.
The usc hot tub heater is protected by a reliable pressure switch and two digital temperature sensors.
Temperature probe is disconnected from the base board and so the hot tub has no feedback to control the temperature.
Turn breaker back on and see if spa powers up if not contact your factory authorized dealer.
If only part of the control panel is not working check for any blinking lights or error messages.
Or a local hot tub technician.
Check cable for any rodent damage crimping or melting.
If the heat indicator is on and no error message appears contact your factory authorized dealer.
If the hot tub does not reset shut off power to the spa and call your supplier for a service.
Examine the panel to see if any moisture is present inside the display.
Spa does not heat.
Check that topside control number works with spa control chip version.
The usc spa pack is equipped with a 5500w 5 5kw 4000w 4kw or 3000w 3kw spa heater.
Inspect circuit board for damage and correct power output.
If you still have no indicator lights on your control panel look underneath for lights on the spa pack.
Check for moisture under glass or on contacts.
Spaside control panel buttons not working correctly.
If part of the control panel is dead or the whole panel is frozen you will want to see if the problem is the circuit board or the control panel.
Check to see if the heat indicator is on or there are any error messages on the topside control panel.
Reset by pushing any button.
Resetting a hot tub control panel.
See if the panel or any buttons are cracked or if it could have possibly gotten wet.
It could also be a bad circuit board but hopefully not.